1.开车前，应检查各部件是否就位、牢固、料槽内是否有物料堵塞。
1.the car before, should check all parts of material jam in place, whether there is firm, tank.

2.每次饲料搅拌机组启动后，应先空转一定时间，详细观察运转是否正常，轴承及电动机的温升等情况，待机械运转正常后方可进料，进料应保持均匀，输送量应掌握适当，不得突增或超载运行。
2.every time feed mixing unit after the start, should first idling for some time, with observation of the operation is normal, bearing and motor temperature rise, to machine normal operation before feeding, feeding should be kept uniform, conveying capacity should master the proper, not sudden increase or overload operation.

3.如无特殊情况，不得负载停机。一般在停止进料后，待料槽内料全部卸完后才能停机。要经常检查刮板链条和驱动装置有无异常，一旦发现问题及时处理解决。
3.in the absence of exceptional circumstances, shall not load down. In general the stop feeding, to tank material are removed after to stop. Should always check the scraper chain and no abnormal driving device, once found problems in a timely manner to solve.

4.运转时严防铁件、大件硬物、杂物等混入输送机内，以免损伤设备或造成其它事故。
4.Operation to prevent iron, large hard objects, and other debris mixed with the conveyor, so as not to damage the equipment or cause other accident.

5.注意保持饲料混合机组中所有轴承和驱动部分的良好润滑，注意刮板链条、头轮、支承导轨、导轮等部件不得涂抹润滑油，以免腐蚀变质。
5. pay attention to maintain good lubrication of all bearings and drive part of the feed mixing unit, note the scraper chain, the head wheel, guide wheel, supporting guide rail and other parts shall not apply lubricating oil, so as to avoid corrosion.