饲料混合机的使用已经非常广泛，但由于其设计缺陷，维护、使用不当，饲料原料含有坚硬杂质，尤其是金属类、矿物质类等杂质都给饲料加工机械的使用带来安全隐患。那么大家在使用之前应该如何处理呢？
如果饲料混合机http://www.jnxiangfu.com/飞轮缺乏安全防护罩，在工作时不小心或者紧急情况下处理意外，易将工作人员服装绞入高速转动的皮带内，也会使跌落在皮带上的异物随着高速运转的皮带甩向在场的工作人员，造成不必要的伤害。如果饲料混合机入料口承载长度不合理，当自动上料机传输上来的原料含有金属物，特别是铁质杂质，如螺钉、垫片、铁块等饲料很快进入粉碎机，轻则打碎筛片、锤片，重则直接击穿机体，对工作人员生命安全造成直接威胁。
If the feed mixer flywheel lack of security guards, careless or handle unexpected emergency situations at work, easy to staff within the high-speed rotating cutter clothing belts, but also make foreign objects fall on the belt with the high speed of the belt Shuaixiang presence of staff, causing unnecessary harm. If the feed mixer inlet port carrying unreasonable length, when the automatic feeder transport up the raw material contains metal, especially iron impurities, such as screws, gaskets, iron and other feed quickly into the grinder, ranging from the fight broken sieve, hammer, while direct breakdown of the body, resulting in a direct threat to the lives and safety of staff.
　　
所以饲料混合机http://www.jnxiangfu.com/在开机前，应该做好各种安全检查和个人防护，此外还应该加质地优良的防护罩可有效避免误伤，加长入料口承载板长度至80厘米~100厘米，并在承载板下面距入料口40厘米左右处加一排吸铁石，就能很有效地防范由于铁质杂质进入粉碎机内造成的损害和危险。在小料入料口高约30厘米~40厘米处加一半封闭盖板，这样既可以方便大量加入原料，如鱼粉、石粉等，也能起到防止扬尘扩散的目的。
So feed mixer before turning it should do various security checks and personal protection, also should be added to the fine texture of the shield can effectively prevent accidental injury, extended the length of the feed inlet bearing

plate 80 cm to 100 cm, and in carrying board below 40 cm from the inlet port at about adding a row of a magnet, can be very effective to prevent damage due to iron impurities from entering and causing a hazard within the mill. In the

small material feed inlet height of about 30 cm to 40 cm and half closed the cover, so that both can be easily added to a large number of raw materials, such as fish meal, powder, etc., can also play the purpose of preventing the spread

of dust.