1、饲料混合机http://www.jnxiangfu.com/长期作业，应固定在水泥基础上，饲料混合机安装完后要检查各部紧固件的紧固情况，若有松动须予以拧紧。
Mixer long-term operation, should be fixed on the basis of cement, feed mixer after installation to check ministries fastening fasteners, if loose must be tightened.

2、要检查饲料混合机皮带松紧度是否合适，电动机轴和粉碎机轴是否平行，饲料混合机的粉碎机启动前，先用手转动转子，检查一下齿爪、锤片及转子运转是否灵活可靠，壳内有无碰撞现象，转子的旋向是否与机上箭头所指方向一致，电机与粉粹机润滑是否良好。
To check the feed mixer belt tension is appropriate, the motor shaft and the shaft is parallel to the mill, feed mixer grinder before launch, the first rotation of the rotor by hand, check the tooth claw hammer and rotor operation is flexible, reliable, shell whether the collision phenomenon within the rotor rotation is consistent with the direction of the arrow on the machine, motor and splintered machine lubrication is good.

3、不要随便更换饲料混合机的皮带轮，以防转速过高使粉碎室产生爆炸，或转速太低影响工作效率，饲料混合机启动后先空转2-3分钟，没有异常现象后再投料工作。
Do not replace the feed mixer pulley, so speed is too high to prevent the crushing chamber to produce an explosion, or the speed is too low affects the efficiency of the first idle feed mixer for 2-3 minutes after start, no anomalies before feeding work.

4、饲料混合机http://www.jnxiangfu.com/操作人员不要戴手套，送料时应站在粉碎机侧面，以防反弹杂物打伤面部，饲料混合机堵塞时，严禁用手、木棍强行喂入或拖出饲料。
Mixer operators do not wear gloves, should feed mill stood side, to prevent debris rebound wounded face, feed mixer when blocked, prohibited by hand, sticks to force feed or out of feed.