1、饲料搅拌机http://www.jnxiangfu.com/有轴向裂纹或径向裂纹现象，导致这种现象的原因是可调质温度达不到，物料熟化程度较差，应提高调质温度，增加调质时的蒸汽量；还有一种可能是切刀位置离较远且钝，使颗粒被碰短或撕裂而非切断。
Feed mixer has an axial or radial crack crack phenomenon, the causes of this phenomenon is adjustable mass temperature of less than, less degree of curing material, quenching temperature should be increased, increasing the amount of steam when quenched; there is a may be far away from the cutter location and blunt, the particles being touched or torn rather than cut short.

2、颗粒料长短不一，应调整切刀距离或调整分料偏转刮位置；  颗粒表面较光滑，但硬度过高，可能是环模压缩比较大，应降低饲料搅拌机环模压缩比。
Pellets of varying lengths, the distance should be adjusted or adjusting knife scraping material deflection position; the particle surface is smooth, but the hardness is too high, it may be relatively large ring mold compression should reduce feed mixer ring mold compression ratio.

3、颗粒表面不很光滑，并且粉化率高，可能是饲料搅拌机环模压缩比较小，应增大压缩孔、环模压缩.
The particle surface is not very smooth, and the powder is high, it may be compressed feed mixer ring mold is relatively small, the hole should be increased compression, compression ring mold.

4、颗粒水份偏高时生产产量偏低，并且经常出现堵机现象，可能是减压阀不能起减压效果或输水阀不能起到输水作用，应调整减压阀，使进入调质器蒸汽压力为0.1—0.4MPa，并使输水阀能起到输水作用，也可以相应增加调质温度，因为温度增高有利于物料熟化度的提高，一般温度每升高11℃时物料水份约增加1%。
High water particle production is low yields, and often blocking machine phenomenon, probably can not play decompression valve or water valve can not play the role of water, adjust valves, entering conditioner steam pressure 0.1-0.4MPa,water and water valves can play a role, but also can be a corresponding increase in quenching temperature, because temperature increases will help improve the aging of the material, usually when the temperature is increased by 11 ℃ material moisture an increase of about 1%.