1.机组必须有接地和漏电保护装置,确保工作人员的人身安全。
Unit must be grounded and leakage protection devices to ensure the safety of staff.
2.机器运行时,受,木棒,铁骑严禁伸入机器内,不得打开机器维修门。
When the machine is running by, sticks, cavalry prohibited inserted into the machine, do not open the door machine maintenance.
3.喂料口堵塞时请勿用手,木棒,铁棍等物料强行喂入,可暂停机器待喂料口清理后再继续工作。
Do not hand when feeding port blockage, sticks, iron rods and other materials forced feeding, feeding port can pause the machine to be cleaned before continuing work.
4.一般情况下请勿带负荷启动机组。待机器运转正常时,调整控制插板至适当位置,主副料应均匀喂料,以电机不超负荷为准。
Under normal circumstances do not start with a load unit. Until the machine is operating normally, adjust the control card to the appropriate location, primary and secondary materials should be uniform feed to the motor is not overloaded prevail.
5.更换孔径小于4毫米以下筛片时,上料管上设置的进料插板应调整适当,否则上料多容易卡死磨盘,损坏筛底,烧坏电机及电器零件等。
Pore size of less than 4 mm below the replacement screen films, feeding tube feeding flapper setting should be adjusted appropriately, otherwise the material much easier stuck disc, damaged screen at the end, burn out the motor and electrical parts.
6.饲料搅拌机 组应安装在远离火源,通风,透光的场所。
Feed mixer set should be installed away from the fire, ventilation, light place.